beautypg.com

System installation, St300-s/sm, vtr/ddr c – DNF Controls 4000CL-N User Manual

Page 6

background image


6 4000CL-N, NATIVE Protocol

3. SYSTEM INSTALLATION

ST300-S/SM, VTR/DDR C

ONTROLLER


a.

Plug one end of a 9-conductor, RS422 serial cable into the 9-pin connector (VTR 1, VTR
2, VTR 3 or VTR 4) on the rear of the ST300. Plug the other end of the cable into the 9-
pin REMOTE connector on the Video Server.


b.

Connect the +5, +12, -12 VDC POWER SUPPLY into the POWER connector on the rear
of the ST300. Plug the Power Supply into an outlet, 90 VAC to 240 VAC.


c.

Check SETUP MENU prior to using the ST300 to confirm proper Record mode and other
User settable modes. See “CONFIGURING THE PROFILE FOR NATIVE MODE,”
Section 16.a.

Installation is complete.







CONNECTION DIAGRAM

See also other documents in the category DNF Controls Equipment: