DNF Controls 4000CL-N - Manual (Page 7)

7 4000CL-N, NATIVE Protocol
4. LOADING A CLIP
a.
Select a VTR by pressing VTR [1], VTR [2], VTR [3] or VTR [4].
b. Press
[CLIP LIST] to view the list of Clips that exist in the VIDEO SERVER.
The CLIP LIST indicator comes on. The display shows “CREATE NEW CLIP.”
c.
Turn the Wheel. The top line of the display will show “xxxxxxxx:”
Where “xxxxxxxx” is the eight character CLIP ID.
Turn the Wheel clockwise to scroll forward, or counter-clockwise to scroll backward,
through the list of available CLIPs.
You may also type in the numeric ID (if a clip has one), from the keypad.
d. Press
[LOAD] to load the current CLIP ID shown on the top line of the display.
e.
Locate the clip to the desired IN time.
5. CAPTURE FUNCTION
a. SETTING AN IN (OUT) POINT
1)
Locate the clip to the desired IN (OUT) time.
2) Press
[IN] ([OUT]).
The IN (OUT) indicator comes on.
b. CLEARING AN IN (OUT) POINT
Press and hold [DEL] then press and release [IN] ([OUT]).
The IN (OUT) indicator goes off.
c. GANGING CLIPS WITH PREVIOUSLY SET IN POINTS
If a GANG is established with the master having an IN point, the gang relationship will
be relative to the master IN point and all slave IN points will be overwritten.
d. MULTIGANG SUPPORT
2 GANGs are allowed to exist on the ST300 simultaneously. As long as the loading of a
Cue Point or a selection of a gang does not interfere with another gang, any gang is legal.