B. receive cue list function – DNF Controls 4000CL-N User Manual
Page 13
13 4000CL-N, NATIVE Protocol
b.
RECEIVE CUE LIST FUNCTION
The RECEIVE CUELIST function allows you to receive a list of Cue Points from a PC
or from another ST300. Transfer to a PC requires OpSuite 3.0 software, which runs on a
Windows-based computer. Contact DNF Controls for more information.
1)
To Receive Cue Points from the ST300
a)
Connect the VTR4 connector on the back of the ST300 from the VTR4
connector of the transmitting ST300 using RS422 9-pin cable with TX
and RX lines crossed. (A “Turnaround” Cable)
b) Press
[MENU].
c)
Scroll the Wheel until “Receive CUE List? YES=Enter, Exit=ESC” is
displayed.
d) Press
[ENTER] to start receiving.
The Display shows “Waiting to receive” on the first line.
e)
When the Transmitter is ready, transfer starts automatically.
The Display now shows “Receiving cuelist.”
f)
After the transfer is over the display shows “Done-Success! Press any
key…”
g)
Press any key. The display shows “Receive cuelist?” message.
h) Press
[ESC] to exit the MENU mode.
2)
To Receive Cue Points from the PC
a)
Connect the VTR4 connector on the back of the ST300 to one of the
COM ports on the PC using RS422 to RS232 adapter
b)
Repeat steps b-h of the RECEIVE CUE POINTS from the ST300
section.