DNF Controls 4000CL-N - Manual (Page 10)

10 4000CL-N, NATIVE Protocol
9. DUPLICATING A CLIP
a.
To save a copy of a clip, first load the clip.
b.
Set the IN and OUT at the head and tail of the clip.
Press [SHIFT] + [CLIPLIST].
The display will show:
c.
Press [LOAD].
Enter a numeric CLIP ID using the numeric keypad on the ST300.
NOTE: To add looping functions to the created clips, see LOOPING FUNCTIONS,
Section 7.
d. Press [LOAD] to save.
OR
Press [ESC] to abort without saving.
10. TRIMMING A CLIP
a.
To make a sub-clip, first load the clip.
b.
Set both an IN and OUT Point.
c. Press
[SHIFT] + [CLIP LIST].
The display will show:
d.
Press [LOAD], the display shows: “Manually enter ID”
Enter a numeric CLIP ID using the numeric keypad on the ST300.
e.
Press [LOAD] to save the trimmed clip.
OR
Press [ESC] to abort without saving.
“Save Trimmed Clip?”
LOAD=Yes Wheel=Next
“Save Trimmed Clip?”
LOAD=Yes Wheel=Next