DNF Controls 4000CL-N - Manual (Page 19)

19 4000CL-N, NATIVE Protocol
RECEIVE CUELIST Receives Cuelist from another ST300 or a PC.
SET TO PROFILE
MODE
Press Softkey [YES] to set ST300 to parameters currently stored in the Profile.
UNASSIGNED
PORT OPTION
Recovers Profile resources which have been opened by another device.
Press any key to allow the ST300 to report any unassigned resources.
When prompted, select VTRs 1, 2, 3 or 4 for any unassigned resources.
DATA PORT Select the VTR Connector (1-4) through which the cue list may be transmitted or
received.
AUTO
ALIGNMENT
Option will automatically realign slaves which are not on the same connector
as the master. This automatic realignment will occur upon pressing stop or after
one second has elapsed while still. The one-second delayed realignment will
occur only in Shuttle, Slomo and Jog.
ST300 SETUP
Press Softkey beneath ClearCues to clear all Cue Points to 00:00:00:00.
Press Softkey [YES] when asked “Are You Sure?”
Press Softkey beneath SetDefault to set ST300 to default settings.
Press Softkey [YES] when asked “Are You Sure?”
NOTE: Choose default when first setting up the system or when eproms are
upgraded.
ST300 SETUP
Clear Mem SetDefault