DNF Controls 4000CL-N - Manual (Page 12)

12 4000CL-N, NATIVE Protocol
15. TRANSFERRING CUELIST
The TRANSMIT CUELIST function allows you to transmit your list of Cue Points to a PC, using
the provided utility software on the PC, or to another ST300. Transfer to a PC requires OpSuite
3.0 software, which runs on a Windows-based computer. Contact DNF Controls for more
information.
a. TRANSMIT CUE LIST FUNCTION
1) TO TRANSMIT CUE POINTS TO THE ST300
a)
Connect the VTR 4 connector on the rear of the ST300 to the VTR4
connector of the receiving ST300 using an RS422 9-pin cable with TX
and RX lines crossed. (A “turnaround” cable)
b) Press
[MENU].
c)
Scroll the Wheel until “Transmit CUE List? YES=Enter, Exit=ESC” is
displayed.
d) Press
[ENTER] to start transmitting.
The Display shows “Waiting to transmit” on the first line.
e)
When the Receiver is ready, transfer starts automatically.
The Display now shows “Transmitting cuelist.”
f)
After the transfer is over, the display shows “Transfer is over” for one
second, then shows “Waiting to transmit” again.
g)
Connect another ST300 to transmit the list again.
OR
Press [ESC] twice to exit the MENU mode.
2) TO TRANSMIT CUE POINTS TO THE PC
a)
Connect the VTR4 connector on the back of the ST300 to one of the
COM ports on the PC using a RS422 to RS232 adapter.
b)
Repeat steps b-g of the TRANSMIT CUE POINTS to the ST300
section.
The RECEIVE CUELIST function allows you to receive your list of Cue Points
from a PC or from another ST300.