DNF Controls 2034CL-N - Manual (Page 9)

9 2034CL-N, 300 Clip Instant Access System, Profile, NATIVE Protocol
d. LEARN ON THE SHOTBOX
1) Press
[LEARN].
2)
Select Bank and press Shotkey
7. RECALL
a. RECALL ON THE ST300
1)
Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE],
or by manually entering the Cue Point using the numeric keypad.
The selected Cue Point number is shown on the bottom line of the display.
2) Press
[LOAD] on the ST300.
The ST300 will automatically load the Learned clips on the Learned VTRs, cue
the clips to the Learned time, then set the Learned GANG mode.
b. RECALL ON THE SHOTBOX
1) Select the desired BANK, pressing BANK [0]-[9].
2) Select the desired Shotkey and press.
8. VIEW CONTENTS OF CUE POINTS ON THE
SHOTBOX
a.
Press and hold [VIEW].
Select the desired bank key, then the desired switch key.
The display will show assignments for all four VTRs in either the first 4 or last 4 buttons
on the first row of display keys.
b.
Press the selected switch again to see which clips are assigned to this Cue Point on VTR3
and VTR4.