DNF Controls 2034CL-N - Manual (Page 17)

17 2034CL-N, 300 Clip Instant Access System, Profile, NATIVE Protocol
TAPE TIME NDF = non-drop frame. DF = drop frame.
STOP MODE PB = while playing a clip, when [STOP] is pressed, the Profile freezes on last good
video.
PB/EE = When [STOP] is pressed the first time, the Profile freezes on last good
video. When [STOP] is pressed a second time, video out is switched to video in.
WIND MODE Press Softkey to select:
HOLD (fast wind is maintained only while key is depressed).
OR
LATCH (fast wind is initiated and maintained with momentary key press).
Select fast wind speed (04X, etc.) by pressing Softkey.
SLOMO
ST300 display shows:
(Non T-Bar Version):
ST300 display shows:
(T-Bar Version)
NOTE - The T-BAR has a fixed speed range of 0 Æ +300 with a detent at +100%
play speed.
For Wheel only:
Press Softkey [SPDRANGE] to select SLOMO speed ranges:
Press Softkey to select: 0 Æ +300 OR -100 Æ +300.
Press Softkey [BACK] to return to SLOMO MENU.
Press [ESC] to exit OR turn the Wheel to select another item.
For Wheel only:
Press Softkey [PRESET] to select the SLOMO Preset Speed Mode
Press Softkey [UPDATE]. When exiting SLOMO mode, the last used speed is
saved in the Preset Speed register.
Press Softkey [STATIC]. The Preset Speed register is NOT updated when exiting
SLOMO mode.
It is only changed by [SHIFT] + [SLOMO] (PRESET SLOMO).
MAX SHUTTLE
SPEED
Press Softkey to select maximum shuttle speed of the Profile.
DATA PORT Select the VTR Connector (1-4) through which the cue list may be transmitted or
received.
TRANSMIT
CUELIST
Transmits Cuelist to another ST300 or to a PC.
RECEIVE
CUELIST SET
TO PROFILE
MODE
Receives Cuelist from another ST300 or a PC.
Press Softkey [YES] to set ST300 to parameters currently stored in the Profile.
SLOMO with: WHEEL
SpdRange Preset
SLOMO with: TBAR
Wheel