Function table – DNF Controls 2034CL-N User Manual
Page 20

20 2034CL-N, 300 Clip Instant Access System, Profile, NATIVE Protocol
19. FUNCTION TABLE
Function Key
Press
Description
GOTO ENTERED
TIME
[SHIFT] + [RECUE]
Search the VTR to the manually entered time.
Use the ST300 numeric keypad. Press [ENTER] or
[RECUE].
GANG [SHIFT] + [VTR #1]
OR
[SHIFT] + [VTR #2]
OR
[SHIFT] + [VTR #3]
OR
[SHIFT] + [VTR #4]
[SHIFT] + [ANY VTR KEY] gang enable mode.
Then, one at a time, press the VTR keys to be included
in the gang. The LED above the key will turn on.
Press the VTR key again to remove from gang, the
LED above the key will turn off.
Press [ESC] to exit and save the gang.
The VTR LEDs that are on show the gang.
The flashing LED shows which VTR is currently
selected (and is monitoring Time Code on the
display).
FFWD
[FFWD]
Press and HOLD to shuttle. Release key to stop. Set
WIND Speed in MENU.
JOG [JOG]
Select JOG mode and enable Wheel.
LAST CUE
[LAST CUE]
Step to the previous Cue Point Location.
NEXT CUE
[NEXT CUE]
Step to the next Cue Point Location.
RECORD [REC]
Places VTR into the Record mode selected by
RECORD MODE in the SETUP MENU. Press
[RECORD] or [RECORD] + [PLAY].
REWIND [RWD]
Press and HOLD to shuttle. Release key to stop. Set
WIND Speed in MENU.
SHUTTLE [SHUTTLE]
Select SHUTTLE mode and enable Wheel.
SAVE TRIMMED
CLIP
[SHIFT] + [CLIP LIST]
Save Clip from the IN to the OUT point.
DISPLAY
CURRENT
DIRECTORY
[SHIFT] +
[NEXT CUE]
Displays the current directory.
DISPLAY
DIRECTORY
CURRENT CUE
POINT IS SAVED
IN
[SHIFT] +
[LAST CUE]
Displays the directory that the clips in the CURRENT
Cue Point are saved in.