DNF Controls 2034CL-N - Manual (Page 8)

8 2034CL-N, 300 Clip Instant Access System, Profile, NATIVE Protocol
e. MULTIGANG SUPPORT
2 gangs are allowed to exist on the ST300 simultaneously. As long as the loading of a
Cue Point or a selection of a gang does not interfere with another gang, any gang is legal.
For example:
Load clips on all four VTRs
Press [SHIFT] + VTR [1]; then press VTR [1], then VTR[2]
Press [ESC]
Press [SHIFT] + VTR [3]; then press VTR [3], then VTR [4]
Press [ESC]
The two gangs will exist without conflict. Learn either one of these gangs into a Cue
Point and load into the Cue Point. The load will never conflict with the other gang.
6. LEARN
NOTE: The ST300 and SHOTBOX share common memory in the ST300.
If a LEARN is done on the SHOTBOX, it doesn’t need to be LEARNed on the ST300.
a. LEARN ON THE ST300
1)
Select a VTR by pressing VTR [1], VTR [2], VTR [3] or VTR [4].
2)
LOAD a Clip. If LEARNING a Gang, load all clips and set the Gang.
3)
Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE] or by
manually entering the Cue Point using the numeric keypad.
The selected Cue Point number is shown on the bottom line of the display.
4)
Press [SHIFT] + [MARK] to initiate the LEARN of the current configuration.
The display shows:
5)
Press VTR [1], VTR [2], VTR [3] or VTR [4] to select the VTRs.
6)
Press [MARK] and the ST300 will: LEARN (save) the Cue Point, CLIP IDs, IN
and OUT Times, Current Directory and Ganged VTRs.
b. LEARNING IN POINTS, SINGLE CLIP
If the learned clip has an IN point marked, the LEARN time will be the IN point. If there
is no learned IN point, then the current location will be the learned time and will be made
the IN point upon learning.
c. LEARNING IN POINTS, GANGED CLIPS
If the master has no IN point, the current location of each clip in the gang will be learned
as IN points. IF the slaves have IN points, the slaved IN points will be overwritten.
Select VTR:
Learn - OK, ESC-Cancel