DNF Controls 2034CL-N - Manual (Page 11)

11 2034CL-N, 300 Clip Instant Access System, Profile, NATIVE Protocol
10. DUPLICATING A CLIP
a.
To save a copy of a clip, first LOAD the clip.
b.
Set the IN and OUT points at the start and end of the clip.
c. Press
[SHIFT] + [CLIP LIST]. The display will show:
d. Press
[LOAD].
Enter a numeric CLIP ID using the numeric keypad on the ST300.
OR
Enter an alphanumeric CLIP ID using the SHOTBOX “qwerty” keyboard, using
NAMING CONVENTIONS, Section 21.c.
To add looping functions to the duplicated clips, LOOPING FUNCTIONS, Section 9, for
more information.
e.
Press [LOAD] to save.
OR
Press [ESC] to abort without saving.
11. TRIMMING A CLIP
a.
To make a sub-clip, first LOAD the clip.
b.
Locate the desired IN, then OUT point.
Press [IN]([OUT]) to set the IN(OUT) point. The IN(OUT) indicator will turn on.
c. Press
[SHIFT] + [CLIP LIST]. The display will show:
d. Press
[LOAD].
e. After
pressing [LOAD], the display shows: “Manually enter ID”
Enter a numeric CLIP ID using the numeric keypad on the ST300.
OR
Enter an alphanumeric CLIP ID using the SHOTBOX “qwerty” keyboard, using the
Naming Conventions in Section 21.c.
f.
Press [LOAD] to save the trimmed clip.
OR
Press [ESC] to abort without saving.
“Save Trimmed Clip?”
LOAD = Yes Wheel = Next
“Save Trimmed Clip?”
LOAD = Yes Wheel = Next