DNF Controls 2034CL-N - Manual (Page 12)

12 2034CL-N, 300 Clip Instant Access System, Profile, NATIVE Protocol
12. RECORDING A NEW CLIP
a.
To make a new clip and insert video from either another Profile channel or an external
source, first press [CLIP LIST]. The Clip List indicator comes on.
b.
Since there is no clip loaded, the display now shows:
c. Press
[LOAD].
d. After
pressing [LOAD], the display shows: “Manually enter ID”
Enter a numeric CLIP ID using the numeric keypad on the ST300.
OR
An alphanumeric CLIP ID using the SHOTBOX “qwerty” keyboard, using the Naming
Conventions in Section 22.c.
e.
Press [LOAD] to save the new CLIP ID.
OR
Press [ESC] to abort without saving.
f.
Recall the Clip and then start the video that will be inserted.
g. Press
[RECORD].
h. Press
[STOP] when finished.
13. VIEW CONTENT OF CUE POINTS ON THE ST300
a.
Select the VTR to examine the contents of a Cue Point by pressing [1], [2], [3] or [4].
b. Press
[NEXT CUE] or [LAST CUE] to step through the Cue Points.
OR
Enter a 1-, 2- or 3-digit number on the numeric keypad, followed by [ENTER].
The contents of the selected Cue Point are shown on the bottom line of the display.
Create New Clip?
LOAD= OK WHEEL= Next