DNF Controls 2034CL-N - Manual (Page 19)

19 2034CL-N, 300 Clip Instant Access System, Profile, NATIVE Protocol
ST300 SETUP DEFAULTS
RECORD Lockout
CHANNEL, CONNECTOR
ASSIGNMENT
CN1 for all. CHA, CHB, CHC, CHD, respectively.
RECORD RECORD = [REC] Only.
RECALL MODE Normal
LEARN MODE Normal mode
MARK-Q CURRENT Cue Point
TAPE TIME NDF
STOP MODE PB
WIND MODE LATCH
SLOMO with Wheel
MAX SHUTTLE 8 X
DATA PORT CN4
AUTO ALIGNMENT OFF
NOTE: The directory chosen in the MENU will be the directory selected upon reset.
If the Profile’s working directory is changed by other programs, when the ST300 starts it will change to the
directory last chosen from the menu.
When installing an upgrade eprom:
Clear the Cue Point memory
Set factory defaults
Set the directory
Then, reenter the CLIP IDs at the appropriate Cue Points or download them from a PC to which the list has
been previously saved, using the Transfer Utility or Operator’s Suite.
Also, enter into the MENU any changes from the default settings. Failure to follow this procedure may
lead to corruption of the Clips and unpredictable operation.