DNF Controls 2034CL-N - Manual (Page 10)

10 2034CL-N, 300 Clip Instant Access System, Profile, NATIVE Protocol
Advanced Features . . .
9. LOOPING FUNCTIONS
Loop: Play from the IN point to the OUT point continuously.
Play to Loop: Played from the beginning of clip to the OUT point of the clip, then, playback
continues at the IN point of the clip, then the clip plays in a continuous loop from the IN point to
the OUT point.
a. LOOP CLIP
1) Press [LOOP ENABLE] after a clip is loaded to place any clip in loop mode.
To loop clips in GANG mode, the Master Clip should be loaded in loop mode.
All the clips in the Gang will loop when [PLAY] is pressed.
NOTE: Clips will now loop from the IN point to the END of the clip or the OUT
point (if set).
2) Press
[SHIFT] + [LOOP ENABLE] to Play To Loop.
b. SAVING CLIPS THAT AUTOMATICALLY LOOP
To automatically Loop a clip each time it is loaded, DUPLICATE the clip and assign the
suffix “*” to the CLIP ID.
On the ST300: Press [ENTER] + [0] to add a “*” at the end of the clip name
c. SAVING CLIPS THAT AUTOMATICALLY PLAY TO
LOOP
1)
To automatically Play to Loop a clip each time it is loaded, DUPLICATE the
clip and assign the suffix “#” to the CLIP ID.
On the ST300: Press [ENTER] + [1] to add a “#” at the end of the clip name.
2)
Locate the desired IN, then OUT point.
Press [IN]([OUT]) to set the IN(OUT) point. The IN(OUT) indicator will turn
on.
3)
Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE], or by
manually entering the Cue Point using the numeric keypad.
The selected Cue Point number is shown on the bottom line of the display.
4)
Press [SHIFT] + [MARK] to initiate the LEARN of the current configuration.
The display shows:
5)
Press VTR [1], VTR [2], VTR [3] or VTR [4] to select the VTRs.
6)
Press [MARK] and the ST300 will: LEARN (save) the Cue Point, CLIP IDs, IN
and OUT Times, Current Directory and Ganged VTRs.
Select VTR:
Learn - OK, ESC-Cancel