DNF Controls 2034CL-N - Manual (Page 16)

16 2034CL-N, 300 Clip Instant Access System, Profile, NATIVE Protocol
Reference . . .
18. SETUP MENU
Press [MENU]. The MENU indicator will turn on.
Turn the Wheel to select item to change.
Press [MENU] OR use the Softkeys to change the desired mode for that option.
Turn the Wheel at anytime to select another item.
Press [ESC] at anytime to exit SETUP MENU. The MENU indicator will turn off.
IMPORTANT NOTE: Please set the following MENU items during initial installation.
ST300 Setup: Clear Mem; Set Defaults
ST300 Config: Select Directory
MENU MODES (Turning wheel Clockwise)
DISPLAY
SOFTWARE
VERSION
The version number and date for the currently stalled software is displayed.
For example:
RECORD MODE Press Softkey to select the desired mode: Lockout or Crash (Full).
CHANNEL
CONNECTOR
ASSIGNMENT
Press VTR key for CH (Channel) and CN (Connector) assignment.
RECORD
LOOP TIME
Press VTR keys for Record Loop Length.
Then, enter HH:MM:SS:FF.
RECORD Press Softkey to select single button or 2-button record.
RECORD = [REC] Only OR [REC] + [PLAY]
RECALL MODE Press Normal or Redirect (Redir).
If [REDIR] is on: The Clip will be REDIRECTED to load on the currently selected
VTR.
If [NORMAL] is on: The Clip will be loaded on the VTR it is LEARNED into.
LEARN MODE In normal mode, LEARN the IN/Current time and OUT points as well as any gang
information.
In CLR_LRN mode, the IN and OUT points are cleared after LEARN is done. This
is used to set multiple Cue Points with individual IN and OUT points in the SAME
video clip.
MARK-Q Press Softkey to:
Enable ADVANCE to next Cue Point, when [MARK] is pressed.
OR
Maintain CURRENT Cue Point when [MARK] is pressed.
2034CL-N V3.0
011400