Comtech EF Data SLM-5650A Vipersat - Manual (Page 31)

Chapter 2 - Quick Start Configuration 2-7
Initial Configuration
Vipersat networks. For networks that call for BPM, see the section
“Routing Mode” on page 3-6.
3. Save the settings to flash by selecting Save from the Main Menu bar.
Set the IP Addressing
1. From the LAN submenu, select Interface to open the LAN Interface page
(figure 2-5).
The MAC Address is displayed as a read-only field.
Figure 2-5 LAN Interface Page
2. Select Single or Dual IP Addressing Mode (default=Single).