Comtech EF Data CMR-8500 Manual - Manual (Page 67)

CMR-8500 DVB IP Encapsulator Revision 2
Chapter 4. Device Management via User Interfaces
4.2.5.5 Configuration: Configure Network
Figure 4-26. CMR-8500 Terminal Interface Configure Network Menu
The Network Management Menu provides the following selections:
1 – Configure GigE1 Interface - Prompts for the IP address and subnet mask for the GigE1 interface.
2 – Configure GigE2 Interface - Prompts for the IP address and subnet mask for the GigE2 interface.
M – Configure Management Interface - Prompts for the IP address, subnet mask, and VLAN Support
for the Management interface.
G – Configure Default Gateway - Enter the Default Gateway for this unit. This should be for the
Management interface.
T – Enable/Disable Telnet – Enables or disables Telnet access to the CMR-8500.
P – Set Web/FTP/Telnet Ports - Allows changes to the default port settings for web, Telnet, and FTP
access to the CMR-8500.
S – Save Configuration - Saves changes made permanently. If changes are made but NOT saved, then
changes will be lost upon the next reset of the CMR-8500.
X – Exit - Exit this menu and return to previous menu.
4-35