Comtech EF Data LPOD User Manual
Page 57
LPOD C-, X-, or Ku-Band Outdoor Amplifier / Block Up Converter (BUC)
MN-LPOD
Updating Firmware
Revision 10
3–3
o
Your serial connection may use either an user-fabricated adapter cable to connect
the User PC serial port to the LPOD, or the optional CLC-10 Handheld Terminal (part
of M&C Accessory Kit (CEFD Kit KT-0020518). The following example depicts use of
the CLC-10 for 1:1 Redundant or Standalone serial connection:
B. On the User PC – If not using the CLC-10, configure the terminal emulator program if
applicable.
Refer to your terminal emulator program HELP feature or user guide for
operating and configuration instructions.
Configure the utility program serial port communication and terminal display operation:
• 38400 bps (Baud Rate)
• 8 Data Bits
• 1 Stop Bit
• Parity = NO
• Port Flow Control =
NONE
• Display New line Rx/Tx: CR
• Local Echo = ON
C. On the LPOD – Power up the unit. Your power connection varies depending on your
ordered unit.
See Sect. 2.2.3 Connector ‘J3 | POWER IN’ (AC Power Mains) or Sect. 2.2.4
Connector ‘J3 | POWER IN’ (DC Power Mains) in this manual for your specific
power connectors.