Comtech EF Data LPOD - Manual (Page 46)

LPOD C-, X-, or Ku-Band Outdoor Amplifier / Block Up Converter MN-LPOD
System Connections, Installation and Startup Revision 10
2–6
2.3.4 Connector ‘J3 | POWER IN’ (DC Power Mains)
WARNING! FOR SAFETY REASONS, TAKE CARE TO NOTE THAT THE ‘J3’ DC POWER
CONNECTION PIN ASSIGNMENTS FOR EACH SPOD UNIT ARE NOT THE SAME.
FAILURE TO CAREFULLY REVIEW THE INFORMATION PROVIDED IN THE SECTIONS
THAT FOLLOW MAY RESULT IN PRODUCT DAMAGE OR PERSONAL INJURY.
For all LPOD models, the prime power input requirement is 38-72 VDC. The total power required
from the prime power supply depends on the model used. Please refer to Sect. 1.5 Summary of
Specifications.
2.3.4.1 LPOD PS 1 ‘J3 | POWER IN’ (DC Power Main)
The mating connector specification and the pin assignments (Table 2-4) unique to
the LPOD PS 1 DC power interface are as follows:
Mating Connector: CEFD P/N CN/STPG04F01 (Glenair IPT06E-12-4-SSR-F7).
Table 2-4. LPOD PS 1 ‘J3 | POWER IN’ Pin Assignments
Pin LPOD PS 1 Assignment
A V+
B GND
C V-
D NO CONNECT
2.3.4.2 LPOD PS 1.5 ‘J3 | POWER IN’ (DC Power Main)
The mating connector specification and the pin assignments (Table 2-5) unique
to the LPOD PS 1.5 DC power interface are as follows:
Mating Connector: CEFD P/N CN-0020517 (MS3116E-14-5S(476), Amphenol
PT06E-14-5S(476)).
Table 2-5. LPOD PS 1.5 ‘J3 | POWER IN’ Pin Assignments
Pin LPOD PS 1.5 Assignment
A +48V
B +48V
C -48V
D -48V
E GND