Comtech EF Data LPOD User Manual
Lpod
IMPORTANT NOTE: The information contained in this document supersedes all previously published
information regarding this product. Product specifications are subject to change without prior notice.
Part Number MN-LPOD
Revision 10
LPOD
Outdoor Amplifier / Block Up Converter (BUC)
Installation and Operation Manual
Table of contents
Document Outline
- mn-lpod_10.pdf
- INSIDE COVER
- TABLE OF CONTENTS
- TABLES
- FIGURES
- PREFACE
- Chapter 1. INTRODUCTION
- Chapter 2. SYSTEM CONNECTIONS, INSTALLATION and STARTUP
- 2.1 Cabling Connection Types
- 2.2 LPOD Cabling Connections
- 2.3 Interface Connectors
- 2.3.1 Connector ‘J1 | LBAND IN’ or ‘J1 | Tx IN’
- 2.3.2 Connector ‘J2 | RF OUT’
- 2.3.3 Connector ‘J3 | POWER IN’ (AC Power Mains)
- 2.3.4 Connector ‘J3 | POWER IN’ (DC Power Mains)
- 2.3.5 Connector ‘J6 | COM1’ (Remote Communications and Discrete Control Port)
- 2.3.6 Connector ‘J9 | OUTPUT SAMPLE’ (PS 2 Only)
- 2.3.7 Connectors ‘J10 | MODEM Rx’ and ‘J11 | LNB’ (Optional Interfaces)
- 2.3.8 Ground Connector
- 2.4 Standalone Installation of the LPOD
- 2.5 Power-up the LPOD
- Chapter 3. UPDATING FIRMWARE
- Chapter 4. ETHERNET-BASED REMOTE PRODUCT MANAGEMENT
- 4.1 Overview
- 4.2 Ethernet Management Interface Protocols
- 4.3 SNMP Interface
- 4.4 Telnet Interface
- 4.5 Web Server (HTTP) Interface
- Chapter 5. SERIAL-BASED REMOTE PRODUCT MANAGEMENT
- Appendix A. 1:1 REDUNDANCY
- Appendix B. CABLE DRAWINGS
- Appendix C. MAINTENANCE
- BACK COVER