Comtech EF Data SMS-458B - Manual (Page 118)

SMS-458B Modem Protection Switch Revision 2
Remote Control Specification MN/SMS458B.IOM
B–10
B.14 Load Modem Configurations
These commands tell the switch to poll the specified modems for configuration information (via the modem remote control serial
communications link). Configurations received without error are loaded into the switch memory.
Load All Active
Modems
Configurations Command:
Response: >add/LMC_ALL’cr’
MOD_1_yyy’cr’
DMD_1_yyy’cr’
MOD_2_yyy’cr’
DMD_2_yyy’cr’
MOD_3_yyy’cr’
DMD_3_yyy’cr’
MOD_4_yyy’cr’
DMD_4_yyy’cr’
MOD_B1_yyy’cr’
DMD_B1_yyy’cr’
MOD_B2_yyy’cr’
DMD_B2_yyy’cr’’lf’]
Where: yyy = OK/FLT
This command load all the active modem configurations
and gives status of the load process (OK/FLT).
Note: Reponses shown is for a system with all possible
modulators and demodulators active. Only active
modulator and demodulator configurations will be loaded
and load status reported.
Load Prime
Modem
Configuration Command:
Response >add/LMC_x’cr’
MOD_x_yyy’cr’
DMD_x_yyy’cr’’lf’] Where: x = 1 to 4 (prime modem numbers)
yyy = ok or FLT
Load Backup
Modem
Configuration Command:
Response >add/LMCBx’cr’
MOD_Bx_yyy’cr’
DMD_Bx_yyy’cr’’lf’] Where: x = 1 or 2 (backup modem number)
yyy = ok or FLT
B.15 Verify Modem Configuration(s)
These commands tell the switch to poll the specified modem9s) for configuration information (via the modem remote control serial
communications link). The received configuration(s) are compared to the last loaded configuration(s).
Verify All Active
Modems
Configuration(s)
Command:
Response: >add/VMC_ALL’cr’
MOD_1_yyy’cr’
DMD_1_yyy’cr’
MOD_2_yyy’cr’
DMD_2_yyy’cr’
MOD_3_yyy’cr’
DMD_3_yyy’cr’
MOD_4_yyy’cr’
DMD_4_yyy’cr’
MOD_B1_yyy’cr’
DMD_B1_yyy’cr’
MOD_B2_yyy’cr’
DMD_B2_yyy’cr’’lf’] Where: yyy = ok or FLt
This command verifies all the active modem
configurations and returns status.
Note: Responses shown is for a system with all
possible modulators and demodulators active. Only
active modulator and demodulator configurations will
be verified and reported.
Verify Prime
Modem
Configuration Command:
Response: >add/VMC_x”cr’
MOD_x_yyy’cr’
DMD_x_yyy’cr’’lf’]
Where: x = 1 to 4 (prime modem numbers)
yyy = OK/FLT
Verify Backup
Modem
Configuration Command:
Response: >add/VMC_Bx”cr’
MOD_Bx_yyy’cr’
DMD_Bx_yyy’cr’’lf’]
Where: x = 1 or 2 (backup modem numbers)
yyy = OK/FLT