Comtech EF Data SMS-458B - Manual (Page 115)

SMS-458B Modem Protection Switch Revision 2
Remote Control Specification MN/SMS458B.IOM
B–7
B.12 Status Commands/Responses
B.12.1 Configuration Status
Prime
Modulator
Configuration
Status Command:
Response:
>add/MCS_x'cr
MA_yyy’cr’
MP_y’cr’
MD_yyy.y’cr’
ADD_yyy’cr’
CU_yyy’cr’
CUA_yyy’cr’’lf’]
Where:
Mod Active (Yes/No)
Mod Priority (1, 2, or 3)
Mod Online Delay
Modem Address
Channel Unit Active
Channel Unit Address (This parameter is returned only
if the channel unit is active (CU_YES)
The modulator configuration status command causes a
block of data to be returned by switch. The block of data
reflects the stored configuration of the modulator selected.
Backup
Modulator
Configuration
Status Command:
Response: >add/MCS_Bx’cr’
MA_yyy’cr’
ADD_yyy’cr’
CU_yyy’cr’
CUA_yyy’cr’’lf’]
Where: x = 1 or 2 (backup modem number)
Mod Active (Yes/No)
Mod Priority (1, 2, or 3)
Mod Online Delay
Modem Address
Channel Unit Active
Channel Unit Address (This parameter is returned only
if the channel unit is active (CU_YES)
The modulator configuration status command causes a
block of data to be returned by switch. The block of data
reflects the stored configuration of the modulator selected.
Prime
Demodulator
Configuration
Status Command:
Response:
>add/DCS_x'cr
DA_yyy’cr’
DP_y’cr’
DT_y’cr’
DD_yyy.y’cr’
ADD_yyy’cr’
CU_yyy’cr’
CUA_yyy’cr’’lf’] Where:
Demod Active (Yes/No)
Demod Priority (1, 2, or 3)
Demod Transponder
Demod Delay
Modem Address
Channel Unit Active
Channel Unit Address (This parameter is returned only
if the channel unit is active (CU_YES)
The demodulator configuration status command causes a
block of data to be returned by switch. The block of data
reflects the stored configuration of the modulator selected.
Backup
Demodulator
Configuration
Status Command:
Response:
>add/DCS_Bx'cr
DA_yyy’cr’
ADD_yyy’cr’
CU_yyy’cr’
CUA_yyy’cr’’lf’ Where:
Demod Active (Yes/No)
Modem Address
Channel Unit Active
Channel Unit Address (This parameter is returned only
if the channel unit is active (CU_YES)
The demodulator configuration status command causes a
block of data to be returned by switch. The block of data
reflects the stored configuration of the modulator selected.