Comtech EF Data SMS-458B - Manual (Page 113)

SMS-458B Modem Protection Switch Revision 2
Remote Control Specification MN/SMS458B.IOM
B–5
B.9 Demodulator Configuration Commands/Responses
B.9.1 Prime Demodulator Configuration Commands/Responses
Demodulator
Active Command:
Response:
Status:
Response: >add/DA_x_yyy'cr''lf']
>add/DA_x_yyy'cr''lf']
Where: x = 1 to 4 (prime demodulator number)
yyy = Yes or No
Demodulator
Priority Command:
Response:
Status:
Response: >add/DP_x_y'cr''lf']
>add/DP_x_y'cr''lf'] Where: x = 1 , 2, 3, or 4
y = 1, 2, 3, or 4
Where
1 = High
2 = Medium
3 = Low
Demodulator
Transponder Command:
Response:
Status:
Response: >add/DT_x_y'cr''lf']
>add/DT_x_y'cr''lf'] Where: x = 1 to 4 (prime demodulator number)
y = 1, 2, 3, or 4 (transponder number, 4 transponder
option)
y = 1, 2, 3, 4, 5, 6, or 7 (transponder number, 7
transponder- option)
Note: See ‘DTO_ ‘ command for definition of downlink
transponder option.
Demodulator
Online Delay Status
Response:
>add/DD_x_yyy.y'cr''lf']
>add/DD_x_yyy.y'cr''lf']
Where: x = 1 , 2, 3, or 4 (Prime demodulator number)
yyy.y = 0.5 to 127 (time in increments of 0.5
seconds)
Auto
None
B.10 Backup Demodulator Configuration Commands/Responses
Backup
Demodulator
Active Command:
Response:
Status:
Response: >add/DA_Bx_yyy'cr''lf']
>add/DA_Bx_yyy'cr''lf']
Where: x = 1 or 2 (Backup demodulator number)
yyy = Yes or No
Note: Backup No. 2 can not be active if the downlink
transponder option is specified to be 7. See the ‘DTO_”
command.