Comtech EF Data SDM-9220 - Manual (Page 84)

SDM-9220/9230 Hardware Installation Guide
5-6 Memotec Inc.
5.4 Ethernet Ports
5.4.1 Ports
• 2 fully routed Ethernet IEEE 802.3 LAN interfaces
• RJ-45 10/100BaseT connectors
• Each port can be configured with 2 IP addresses, providing a maximum of 4 IP
addresses per unit
• Auto-detect speed, 10 or 100 Mbps
• Frame types: Ethernet II, IEEE 802.2, 802.3, SNAP
• Ethernet interface: Ethernet II and IEEE 802.2, 802.3
• Standards: IP RIP V1/V2 or Static, OSPF, NAT, IP Multicast IGMP V1/V2 PIM-
DM, BOOTP/DHCP Relay, DHCP client, IPX RIP and SAP, LLC2, 802.1p/q pri-
oritization and VLAN, 802.1D Spanning Tree Protocol (STP), MAC Layer
• Filter Criteria: Based on protocol, address (source, destination or SAP) or custom
filtering.
For information on connecting to the LAN hub, refer to “Connecting the LAN Hub” on
page 4-35 .
5.4.2 LAN Status LEDs
Two pairs of LAN status indicators are located below the Ethernet ports on the rear panel
of the SDM-9220/9230 chassis (refer to
“Rear View of the SDM-9230 UAC” on page 5-
2 ). The LEDs for Ethernet port 1 are located on the left, and those for Ethernet port 2 are
on the right.
These LEDs indicate the following:
• LINK: Goes on when the corresponding LAN connection passes the Link Integ-
rity test. In addition, the LED color indicates the LAN speed:
- Amber: Link integrity at 100 Mbps
- Green: Link integrity at 10 Mbps
- Off: No link integrity signal detected.
• ACT: Goes on (green) when there is activity on the corresponding LAN port
(LAN traffic transmitted or received).