beautypg.com

Comtech EF Data SDM-9220 User Manual

Page 106

background image

SDM-9220/9230 Hardware Installation Guide

5-28

Memotec Inc.

To connect this cable:

1.

Connect one end of the cable to the RJ-45 connector on the interface card.

2.

Connect the other end to the RJ-45 connector on the trunk side of the PBX

As an alternative, you can cut it off and punch on a Telco/PTT block termination.

CAUTION:

:

For important E&M wiring and grounding considerations,

refer to

“E&M Wiring and Grounding” on page 4-23

.

NOTE:

You must install a ferrite on each cable connected to an E&M port on an

SDM-9220 or SDM-9230 (both UAC and DC models) in all countries.
These ferrites are

not

provided with the SDM-9220/9230product package.

For instructions, turn to

“Installing the Ferrites (EMI Filters)” on page 4-26

.

Figure 5-15: RJ-45 pinout (female jack) for E&M interface card

This manual is related to the following products: