2 preparing the site, 1 what you will need, Preparing the site -5 – Comtech EF Data SDM-9220 User Manual
Page 41: What you will need -5
Unpacking
Memotec Inc.
3-5
3.2 Preparing the Site
3.2.1
What You Will Need
For trouble-free installation of the NetPerformer hardware make sure you have the
following on hand:
•
The SDM-9220 or SDM-9230 unit, with all accessories, cables and optional
hardware you received in the product package. Refer to
•
At least one of the following configuration and management access devices:
- A console terminal (TTY terminal or a PC equipped with terminal emulation
software) for direct or dial-up connection to the console port at the rear of the
SDM-9220/9230 unit, or
- A TELNET network device accessed through IP connectivity over LAN/
WAN, or
- An SNMP agent accessed through IP connectivity over LAN/WAN.
NOTE:
When you first take the SDM-9220/9230 out of the box, the only configura-
tion device you can use is the console terminal, since the unit does not yet
have an IP address. For details, see
“Connecting the Console Terminal” on
CAUTION:
If you intend to use the HyperTerminal‰
communications program as your console terminal, read the
“Notice Concerning HyperTerminal Connections” on page 1-10
•
A sufficient number and length of cables for all ports:
-
One RJ-48 to RJ-48 cable for each T1/E1 or ISDN-BRI S/T port (at least
26AWG, or 0.4mm)
- Two BNC coaxial cables for each T1/E1 port that will be configured for E1-
75 operations
NOTE:
An adaptor is also required for an E1-75 connection
on an E1/T1 port
.
The
following adaptor is available:
RJ-48 to E1-75 dual BNC (Part No. AG2CA0001). See