4 configuring push to talk, 1 configuring the e&m/ptt physical port (link), Configuring push to talk -8 – Comtech EF Data SDM-9220 User Manual
Page 136: Configuring the e&m/ptt physical port (link) -8
SDM-9220/9230 Hardware Installation Guide
9-8
Memotec Inc.
9.4 Configuring Push To Talk
To configure the NetPerformer for an analog voice application:
•
Configure the physical port on the interface card, using the
SLOT/LINK
option of
the
SETUP
command (see next section)
•
Set up all E&M/PTT channels using the
SLOT/CHANNEL
option of the
SETUP
“Configuring the E&M/PTT Channels (CHANNEL)” on page 9-
9.4.1
Configuring the E&M/PTT Physical Port (LINK)
To define the physical port on an E&M/PTT interface card:
1.
Enter the menu sequence:
SE
SLOT
2.
Select the Slot number
3.
Enter LINK
4.
Set the Status to ENABLE to activate the physical link
NOTE:
If the physical link is disabled, all voice channels associated with this port are
disabled as well. You can continue with channel configuration, and then
enable the link at a later time.
Figure 9-2: SETUP Command Paths in the CLI Tree for Push To Talk Support