1 about unpacking the unit, 1 selecting a location, 2 size requirements – Comtech EF Data SDM-9220 User Manual
Page 38: About unpacking the unit -2, Selecting a location -2, Size requirements -2, Front view of the sdm-9220/9230 -2
SDM-9220/9230 Hardware Installation Guide
3-2
Memotec Inc.
3.1 About Unpacking the Unit
This chapter outlines preparatory steps that should be executed before you install and
configure the SDM-9220/9230:
•
Selecting a location (see next section)
•
“Preparing the Site” on page 3-5
).
3.1.1
Selecting a Location
To ensure that the SDM-9220/9230 functions properly, you should install the unit in an
appropriate location which satisfies certain criteria for size, connection distance and
ambient environment.
CAUTION:
:
Unit must be installed in a restricted access location.
3.1.2
Size Requirements
•
Select a standard 19" (48 cm) equipment rack or a hard, flat surface that is:
-
Near an easily accessible AC or DC power source
-
Capable of supporting the weight and size of the SDM-9220/9230, its cabling
and attached equipment.
•
To ensure proper ventilation of the SDM-9220/9230, leave 5 cm (2 inches) of
unobstructed space around the unit chassis.
•
Ensure that a sufficient number of shelves, supports, racks and cabinets are avail-
able to safely house all equipment.
Figure 3-1: Front View of the SDM-9220/9230