beautypg.com

5 fcc part 15 statement, 6 fcc part 68 statement, 7 connection to the telephone line – Comtech EF Data SDM-9220 User Manual

Page 28: Fcc part 15 statement -8, Fcc part 68 statement -8, Connection to the telephone line -8

background image

SDM-9220/9230 Hardware Installation Guide

2-8

Memotec Inc.

2.2.5

FCC Part 15 Statement

This digital equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna

Increase the separation between the equipment and receiver

Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.

2.2.6

FCC Part 68 Statement

This equipment complies with Part 68 of the FCC rules and the requirement adopted by

ACTA of the United States.

On the product nameplate of this equipment (located on the underside of the product
chassis) is a label that contains, among other information, a product identifier in the format
US:AAAEQ##TXXXX.

If requested, this number must be provided to the telephone company.

2.2.7

Connection to the Telephone Line

This equipment uses jacks for connection to the telephone line. You must, upon,
request, provide the following “USOC Jack type” to your local telephone com-
pany:

-

For equipment equipped with the interface card 100-1107-003/004, the
USOC jack type: RJ11C

-

For equipment equipped with the interface card 100-1111-001/002, the USOC
jack type: RJ48C

This equipment cannot be used on the public coin phone service provided by the
telephone company. Connection to party line service is subject to state tariffs.

Your telephone company may discontinue your service if your equipment causes

harm to the telephone network. They will notify you in advance of disconnection,
if possible. During notification, you will be informed of your right to file a com-
plaint to the FCC.

Occasionally, your telephone company may make changes in its facilities, equip-
ment, operation, or procedures that could affect the operation of your equipment.

This manual is related to the following products: