Comtech EF Data CRS-180 - Manual (Page 77)

CRS-180 70/140 MHz IF 1:1 Redundancy Switch MN/CRS180.IOM
Cables and Connections Revision 11
5–17
5.2.2.3 PMSI Interface Example
The Pre-Mapped Symbol Interface (PMSI) is an EIA-485 point-to-point bus system where one
device transmits, and the other device on the bus is configured to receive. It is a function
associated with DoubleTalk ® Carrier-in-Carrier ® (CnC ® ) that permits the modulator in a selected
unit to provide a direct copy of its output (the outbound interferer) to the offline modem in a
1:1 pair. The offline modem then takes the PMSI signal and uses it for its own CnC ® reference.
You must take specific configuration steps to enable CnC ® in your CDM-625/A 1:1 pair before
you can make any switch configurations, This ensures proper operation of the pair within a
configured CRS-180 1:1 Redundancy System.
Chapter 4. MODEM AND SWITCH CONFIGURATION
Use of PMSI requires that you connect and secure the CDM-625/A Multi-drop CnC ® Plus 1:1
Cable CA-0000276 (2X DB-9M, 1’) between the Redundant Modem and the Traffic Modem using
CnC. See Figure 5-16.
The CA-0000276 Multi-Drop CnC PLUS 1:1 Cable bypasses the CRS-180 L-Band 1:1
Redundancy Switch.
CEFD P/N Qty Description
CA-0000276 1 CDM-625/A Data Cable – Shielded, Multi-drop CnC ® Plus, 1:1, (2X) DB-9M, 1’
Figure 5-16. CDM-625/A PMSI 1:1 Example