Comtech EF Data CRS-180 - Manual (Page 101)

CRS-180 70/140 MHz IF 1:1 Redundancy Switch MN/CRS180.IOM
Cables and Connections Revision 11
5–41
5.6.2 Modem-to-User Data Interface Kit and Connection Examples
In addition to the basic Modem-to-Switch cabling shown previously, a number of data interface
configuration kits are available for use with the CDM-710 Broadcast Satellite Modem. Separate
cabling kits are needed for these CDM-710 data interfaces.
While different data interface cards may be installed into both Interface slots, only
one data interface type is operable at a given time. The data interface combinations
allowable in the CDM-710 chassis Interface Slots 1 and 2 are as follows:
Interface Slot 1 Interface Slot 2
ASI (CDI-40) None
HSSI (CDI-60) None
None GbE (CDI-70)
5.6.2.1 Modem-to-User Non-IP Data Interface Kit and Connection
Examples
Figure 5-35. CDM-710 Block Diagram – UserModemSwitchTraffic
Figure 5-35 shows the block diagram typical for the kits shown in Sects. 5.6.2.1.1 and 5.6.2.1.2.
Separate cabling kits are needed for these CDM-710 data interfaces. For example, Sect.
5.6.2.1.1 identifies the interface kit used with the CDI-40 ASI Data Interface.
With the exception of the CDI-70 Gigabit Ethernet data interface configuration shown in Sect.
5.5.2.2, which uses user-provided Ethernet cables and Layer 2 Switch, you must use one
interface kit per 1:1 modem pair for each interface (see examples for specific quantities).