Comtech EF Data CRS-180 - Manual (Page 113)

A-1
Appendix A. CABLE DRAWINGS
A.1 Overview
This appendix provides technical specification drawings for the cables used with the CRS-180 70/140 MHz IF 1:1 Redundancy Switch.
These cables are divided into two categories – Control Interface Cables (Section A.2), and IF/Data Interface Cables (Section A.3).
The European EMC Directive (EN55022, EN50082-1) requires that you use properly shielded cables for DATA I/O. These
cables must be double-shielded from end-to-end, ensuring a continuous ground shield.
The tables in Sections A.2 and A.3 cross-reference the modem-specific cabling figures featured in Chapter 5. CABLES AND
CONNECTIONS.