Comtech EF Data OM20 - Manual (Page 85)

OM20 Universal Outdoor Modem Web Browser/Remote Protocol
MN-OM20– Revision 5 6–11
IP TEST: The IP Test boot mode has a similar behavior to the
default boot mode. The Terminal, IP, SNMP, FTP and Web
parameters changed by the default setting will also be reset by
the IP Test boot mode. However, instead of the IP addresses
being set to an unreadable address, it will be set as follows as
shown in Table 6-4:
IP TEST
IP ADDRESS MASK: 255.255.255.0
MODEM IP ADDRESS: 192.168.000.238
SERVER IP ADDRESS 192.168.000.101
ROUTER IP ADDRESS: 192.168.000.102
Table 6-4. IP Test
IP Address Mask: {XXX.XXX.XXX.XXX}
The IP Address Mask of the local network. The mask is
expressed in a decimal format, and must be a valid TCP/IP
Mask. This field should be set before changes are made to the
Modem or Router Address.
Modem IP Address: {XXX.XXX.XXX.XXX}
The IP Address of the modem. This address should be consistent
for the mask defined. This address is expressed in decimal
format. Broadcast and loop back addresses will not be allowed.
These are addresses with all subnet bits set to 0’s or 1’s.
Server IP Address: {XXX.XXX.XXX.XXX}
The IP Address of the Boot Server and the address of the SNMP
Trap Server when SNMP is active. If a server is used and there
is no local router, this address must be consistent with the
modem address. If a router has been specified, the address is
presumed to be reachable via the router. Broadcast and loop
back addresses will not be allowed. These are addresses with all
subnet bits set to 0’s or 1’s.
Router IP Address: {XXX.XXX.XXX.XXX}
The IP Address of the Local Network Router. If a router is
present on the local network, this address must be consistent
with the IP Mask and the subnet of the modem. If no router is
present, then the address should be set to a foreign address. This
address is expressed in decimal format. Broadcast and loop back
addresses will not be allowed. These are addresses with all
subnet bits set to 0’s or 1’s.