Comtech EF Data OM20 - Manual (Page 116)

OM20 Universal Outdoor Modem Web Browser/Remote Protocol
MN-OM20– Revision 5 6–42
ES to ES Enhanced: Allows user to select the Interface Baud
Rate. This selection will allow the user to set rate as listed in
Table 3-3.
SCC: Allows user to select the interface Baud rate. Interface
Rate must be equal to or greater than the In-Band Rate.
ES Bits/Char: {7,8}
Allows the user to choose between 7 or 8 bit data.
INSERT MAP
The Insert Map displays the current programmed Rx Insert map
for the modem. (Refer to Section 3.13, “Drop and Insert
Mapping” in this manual).
Insert Mode: {NONE, T1-D4, T1-ESF, PCM-30, PCM-30C, PCM-31,
PCM-31C, T1-D4-S, T1-ESF-S.}
Insert mode may only be changed from none when the drop and
insert specified is in use.
Submit Map: Allows the user to Submit the Rx D&I Map Time Slots.
Reset Map: Allows the user to reset the Rx D&I Map Time Slots.
T1/E1 Frame Src: T1/E1 FRAME SRC {INTERNAL, EXTERNAL}
Selects the frame source for T1 or E1 framing.
Terrestrial Time Slot: {1-31}
Allows the user to edit the Rx Edit map to specify the terrestrial
slots that will be inserted into the assigned satellite channels.
The satellite channels are fixed and the number of channels are
determined by the data rate. The terrestrial time slots available
are determined by the drop mode.