Comtech EF Data OM20 - Manual (Page 199)

MN-OM20– Revision 5 F–1
Appendix F. Efficient
Drop & Insert (D&I)
F.1 Introduction
The following paragraphs describe the menu structure and procedure for configuring a Radyne
OM20 modem for Efficient Drop & Insert Mode.
F.2 Prerequisite
In order for a modem to be configured for efficient Drop & Insert, the modem must have a G.703
Interface card installed and Open Network Drop & Insert must be enabled. If you modem does
not have the required hardware and/or feature set enabled, you will need to contact your Radyne
salesperson to order the appropriate hardware and/or feature set upgrade. If your modem has the
appropriate hardware, but the software revision is prior to AY, you will need to download the
latest modem firmware from the Radyne FTP website.
The following menus illustrate how to determine whether or not your modem has the required
hardware and feature set options.
SYSTEM
HW/FW CONFIG
FIRMWARE
F05058-AY 6.1 or later required
SYSTEM
HW/FW CONFIG
TERR INTFC BRD
01-AS/4975
or equivalent required
SYSTEM
HW/FW CONFIG