Comtech EF Data OM20 - Manual (Page 19)

OM20 Universal Outdoor Modem Introduction
MN-OM20– Revision 5 1–3
1.1.1 Features/Options Installed at Time of Order
Features installed at the time of ordering are the options pre-installed/initialized in the factory
prior to shipment. Features and options can be reviewed from the GUI or remote port of the
OM20.
Refer to Section 4, “User Interfaces” for information on how to view these features.
Factory installed options are chassis and board configurations that are introduced during
manufacture. These options include (Options are subject to change):
 Input Power: AC 2-5 W BUC (24VDC), AC 8-10W BUC (48 VDC),
 Input Power: DC 2-5 W BUC (24VDC), DC 8-10W BUC (48 VDC)
 Data Rate: 5 Mbps (standard), optional 10, 20 Mbps
 Interface: EIA-530 (standard), Optional Ethernet, G.703, ASI
 M&C Interface – SNMP Ethernet/Web Browser – RS485, RS232
 Viterbi Codec (standard), Optional Sequential Codec
 Optional Custom Reed Solomon
 Optional IBS, IDR, Drop and Insert
 Optional External Reference Input Connector
 Modulation: BPSK, QPSK, OQPSK (standard), Optional 8PSK, 16 QAM
 Optional Turbo, 5Mbps, 20Mbps
 Sequential Codec, and custom programmable Reed Solomon.
 Optional OM73
 Optional DVB
 Optional Cable, Waveguide, Mounting Kits
 M&C Interface – SNMP, Ethernet/Web Browser, RS485, RS232
1.1.2 Software Feature Upgrades
Software Feature Upgrades are a simple and quick way of changing the feature set of an installed
modem. Feature upgrades are how most OM20 options are implemented. Features may be
purchased at any time by contacting a Radyne Corp. salesperson. Refer to Appendix B for
information on how upgrade features.
1.1.3 Future Hardware Options
Hardware options (
Refer to Appendix A ) are purchased parts that can only be installed at a
Comtech Facility. Please contact the Comtech EF Data Customer Service Department for
information not limited to availability and to shipping costs.
Only authorized service personnel should handle and install
optional hardware options.