Comtech EF Data OM20 - Manual (Page 101)

OM20 Universal Outdoor Modem Web Browser/Remote Protocol
MN-OM20– Revision 5 6–27
NEARSIDE: When configured for NEARSIDE AUPC the
maximum Transmit Power is the highest power setting that will
be used by the local modem when the Eb/No decreases below
the Eb/No target.
TARGET Eb/No {4.0 to 16 dB}
This allows the user to set the desired E
b
/N
o
for the local
receiver.
RADYNE AUPC: When configured for Radyne AUPC, this
setting is compared against the remote E
b
/N
o
and commands to
the local modem to increase or decrease the local transmit
power.
EF AUPC: When configured for EF AUPC, this setting is
compared against the local received E
b
/N
o
and commands to the
remote modem to increase or decrease transmit power.
NEARSIDE: When configured for NEARSIDE AUPC, this
setting is compared against the received E
b
/N
o
of the local
modem and commands to the local modem to increase or
decrease transmit power.
TRACKING RATE {0.5 to 6.0}
Allows the user to set the rate at which the commands to increase
or decrease Transmit Power are sent. Each command will result
in a 0.5 dB increase or decrease in Transmit Power from the
remote transmitter. The tracking rate is adjustable from 0.5 dB
per minute to 6.0 dB per minute in 0.5 dB steps. (Only
available when EFAUPC is selected as the framing)
LOCAL CL ACTION {HOLD, NOMINAL, MAXIMUM}
This allows the user to set the Remote Transmit Power Setting to
be used when the local modem receiver loses lock. The setting
can be 'HOLD' (no action taken), 'NOMINAL' (the nominal
Transmit Power Setting is used), and 'MAXIMUM' (the
maximum Transmit Power Setting is used). (Only available
when EFAUPC is selected as the framing)
REMOTE CL ACTION {HOLD, NOMINAL, MAXIMUM}
This allows the user to set the Local Transmit Power Setting to
be used when the remote modem receiver loses lock. The setting
can be 'HOLD' (no action taken), 'NOMINAL' (the nominal
Transmit Power Setting is used), and 'MAXIMUM' (the
maximum Transmit Power Setting is used).
REMOTE AUPC (menu)
The 'REMOTE AUPC CONFIGURATION' Menu contains the
remote configuration parameters for the AUPC Function.
Remote AUPC menus are only available when modem is
configured for EF AUPC