Comtech EF Data OM20 - Manual (Page 34)

OM20 Universal Outdoor Modem OM20 Initial Configuration
MN-OM20– Revision 5 3–2
Standard OM20 Factory Default Configuration Settings
Modulator:
Data Rate: 2.048 Mbps
Mode: Closed Network
Satellite Framing: None
Scrambler: V.35 (IESS)
Drop and Insert: Disabled
Inner FEC: 1/2 Rate Viterbi
Outer FEC: Disabled
Modulation: QPSK
Frequency: 1350 MHz
Modulator Output Power: -20 dBm
Demodulator:
Data Rate: 2.048 Mbps
Mode: Closed Network
Satellite Framing: None
Descrambler: V.35 (IESS)
Drop and Insert: Disabled
Inner FEC: 1/2 Rate Viterbi
Outer FEC: Disabled
Modulation: QPSK
Frequency:
1350 MHz
Interface:
The default will vary depending on the interface type
Ethernet:
IP Address Mask: 255.000.000.000
Modem IP Address: 010.000.000.001
Server IP Address: 010.001.001.001
Router IP Address: 010.000.001.001
IMPORTANT
IP M&C Default Reset
If the unit should lockup or lose communication during the initialization
process, the unit remote interface can be reset using the supplied reset
mating connector. By installing the connector on J2 and cycling power, the
unit communication parameters will be reset to the factory test settings.
Refer to section D for Quick Set-Up Guide
To lock up the modem with an internal loopback feature, enter ‘IF Loopback Enable’ under the
Test Menu.