BECKHOFF BK3xx0 User Manual
Page 81
Notes on the Documentation
Fieldbus Components
79
Enabling/disabling via the 2-byte PLC interface or through KS2000
The terminals are enabled or disabled through table 1, registers 0-31:
Register
Bit
Description
0,1
Assignment for terminal 1
0: DP DataExchange (default)
2: disabled (Multi-Config mode)
2,3
Assignment for terminal 2
0: DP DataExchange (default)
2: disabled (Multi-Config mode)
4,5
Assignment for terminal 3
0: DP DataExchange (default)
2: disabled (Multi-Config mode)
6,7
Assignment for terminal 4
0: DP DataExchange (default)
2: disabled (Multi-Config mode)
8,9
Assignment for terminal 5
0: DP DataExchange (default)
2: disabled (Multi-Config mode)
10,11
Assignment for terminal 6
0: DP DataExchange (default)
2: disabled (Multi-Config mode)
12,13
Assignment for terminal 7
0: DP DataExchange (default)
2: disabled (Multi-Config mode)
0
14,15
Assignment for terminal 8
0: DP DataExchange (default)
2: disabled (Multi-Config mode)
...
...
...
31
14,15
Assignment for terminal 128
0: DP DataExchange (default)
2: disabled (Multi-Config mode)
Note
It can happen under multi-configuration mode that the CfgData exceeds 64 bytes. In such a
case, the CfgData must be enlarged.