Avery Dennison 9450 RASCAL - Manual (Page 77)

Appendix C. Messages
Following are status messages you could receive while using
the 9450 software. Each is accompanied by an explanation as
well as a possible solution.
NOTE: Some Terminate and Stay Resident programs (TSR’s)
may cause problems with the 9450 software. You may
want to disable TSR’s when running 9450.
Monarch does not recommend running the 9450
program under the Windows shell.
Message Description
Error on printer. This is the most common error
message you will encounter.
One of the following may have
caused this problem:
You ran 9450.EXE, not
RUN9450.BAT. Try running the
RUN9450.BAT file.
Your cable is not attached to the
correct communications port.
Make sure it is connected to the
correct port.
The Flow Control on your printer
is not set to DTR. Set it to DTR.
Decimal value = 128 for DTR.
C-1