Avery Dennison 9450 RASCAL - Manual (Page 33)

From this menu, you can:
•
add a bar code field
•
add a text field
•
add a line field
•
add a box field
•
add a graphic location
•
copy a field.
2. Enter the letter (B, T, L, X, G, or C) that corresponds to the
type of field you want to add.
You are prompted for the field specification data.
3. Enter a value at each prompt. Refer to Appendix B, "Field
Specification Data," for valid values. Press ENTER when
you finish defining your field.
You will see a graphic representation of the supply as well
as the field you defined.
4. Use the cursor, which appears as a plus sign (+), to place
the field where you want it. To position the field, use the
arrow keys on the right side of the keyboard or numeric
keypad, or the keys marked PgUp, PgDn, Home and End.
See Chapter 1, "Introduction," for information on how to
use these keys.
The coordinates of the cursor are shown at the top left side
of the format display. The horizontal or "H" coordinate
shows the distance in inches from the left edge of the
format. The vertical or "V" coordinate shows the distance
in inches from the top edge of the format.
4. Designing Formats
4-5