Avery Dennison 9450 RASCAL - Manual (Page 11)

2. Installing the Software
Installing the software is a three-step process:
1. Run the installation program.
2. Configure the software for use with your printer.
3. Print the test format, which is provided on the installation
disk. This format allows you to verify your printer’s
connection to the PC.
Before You Install
Before you install this software on your computer, make sure
your:
•
computer is using DOS 3.1 or later.
•
AUTOEXEC.BAT file includes DOS in the path
statement (e.g., Path = c:\DOS).
•
label printer is installed and connected to your
computer’s serial port.
•
printer’s communication port is set to the following
values:
•
Baud Rate = 9600
•
Stop Bits = 1
•
Parity = None
•
Word Length = 8
•
Flow Control = DTR
2-1