4 operation, 1 start-up and shutdown, 1 turning on the unit – Avery Dennison ALS 104 User Manual
Page 36: 2 starting label dispensing, Dispensing with a product sensor, Dispensing without a product sensor, 3 stopping the dispensing process, 4 . 1 s t a r t - u p a n d s h u t d o w n, Als 104 gb
32
4
O
PERATION
4.1 S
TART
-
UP
AND
SHUTDOWN
ALS
104
GB
4.1.1
Turning on the unit
£
Set the main switch [42A] of the unit to ‘I’ (On).
Machine with dust/splash guard option:
– The main switch [43A] lights, if the machine is swit-
ched on.
£
Operate the main switch.
– Once on, the ALS 104 is in dispensing mode; in
other words, triggering the product sensor will cause
a label to be dispensed.
– More information on the dispensing mode can be
found in the section “Dispensing mode” on page 19.
4.1.2
Starting label dispensing
Dispensing with a product sensor
Once switched on, the ALS 104 is in dispensing mode;
this means that triggering the product sensor will cause
a label to be dispensed.
Prerequisites:
– The label length must be specified
– The product sensor must be connected
– The sensor type (PNP/NPN) must be
properly set.
Dispensing without a product sensor
It is also possible to trigger the dispensing process
without a product sensor:
£
Press the key
briefly.
4.1.3
Stopping the dispensing
process
£
Set the main switch [42A] of the unit to ‘O’ (Off).
[42] Main switch (A) of ALS 104.
[43] Mains switch (A) of ALS 104 with dust/splash guard option.
A
A
4
O
P E R A T I O N
4.1
START-UP AND SHUTDOWN