Avery Dennison ALS 104 - Manual (Page 30)

26
3 B
EFORE OPERATION
3.2 I
NSERTING LABEL MATERIAL
ALS
104
GB
3.2.2 Inserting a label roll
WARNING!
Risk of injury due to moving and rapidly
rotating parts!
£ Before inserting the label roll, ensure that
the device is turned off at the main
switch.
£ Do not under any circumstances turn the
device on before the label strip is
threaded in completely.
Removing spent backing paper
Assuming backing paper has gathered on the rewinder
[30A] :
£ Press the release button [30C].
– The tensioning mechanism of the rewinder is
slackened.
£ Remove the rewound backing paper.
Removing glue residue
£ If necessary, clean the following components:
– Dispensing plate
– Deflection rollers
– Drive rollers
– Pressure roller
£ Follow the directions provided in section
“Maintenance and cleaning” on page 37.
Inserting a new label roll
£ Push the material roll [31A] onto the unwinder as far
as it will go.
£ Rotate the rotary knob [31B] in a clockwise direction
until the label roll sits tightly.
£ Run the label strip around the dancer arm as shown
in the figure [31C].
– The material strip must run in a slightly different
route when using label rolls with a ‘labels facing
inwards’ winding direction. Insert the roll in such a
way that it unwinds in an anticlockwise direction
(see “Threading guide” on page 27).
[30] A Rewound backing paper
B Backing paper path
C Release button
B
C
A
[31] Fasten the label roll to the dispenser (the winding direction
of the roll should be with the labels facing outwards).
A
C
B