Avery Dennison ALS 104 - Manual (Page 35)

31
3 B
EFORE OPERATION
3.3 M
ECHANICAL SETTINGS
ALS
104
GB
3.3.3 Calibrating the label sensor
Positioning the sensor:
£ Release the thumb screw.
£ Position the sensor along the axle in such a way as
to allow it to register the spaces between the labels.
Configuring the sensor:
– The settings required for the sensor depend on the
employed materials. The standard settings are
suitable for many types of label materials.
£ Check whether the LED is lit [41A] when the sensor
is above a space between labels.
– If this is not the case, the sensor must be
configured.
£ You should refer to a qualified technician to help
configure the sensor.
– Configuration instructions: See the service
manual.
[41] Label sensor from Wenglor, model OPT242-P800
B
A