Defining the printspeed tag (optional), Defining the useblackmark tag (optional), Defining the useondemand tag (optional for 6057) – Avery Dennison Pathfinder 6057 LNT Programmer Manual using XML User Manual
Page 57: Defining the sensormode tag (optional)
Creating Job Data 5-3
Defining the PrintSpeed Ta g (Optional)
The PrintSpeed tag defines the print speed in inches per second (ips) for the job.
Valid values include: a float in the range of 1.0 to 5.0.
It contains the following attribute: fixed.
Note:
Serial bar codes, lines, and graphics print at 2.0 ips. Synthetic supplies and special
supplies print at 1.5 ips.
Syntax
Fixed
The printer prints at the s pecified setting until the battery drains. Options:
0 False (default)
1 True
Note :
Fi xed can be enabled for speeds 3.0, 4.0 and 5.0 ips. Fi xed is only recomm ended for
te xt formats where speed is required over print qual ity.
Example
Sets the printer’s speed to 5.0 ips, but allows the speed to vary from 5.0 ips for serial bar
codes, etc.
Defining the Use BlackMark Ta g (Optional)
The UseBlackMark tag specifies if the printer uses the black mark sensor to sense supplies.
Valid values include: 0 (off) and 1 (on). The default is 1.
Syntax
Example
The printer uses the black mark sensor to calibrate and feed labels.
Defining the UseOnDema nd Tag (Optional for 6057 )
The UseOnDemand tag specifies if the 6057 printer uses the optional on-demand sensor. Your
printer may not have an on-demand sensor installed.
Note:
The 6140 printer does not have an on-demand sensor.
Valid values include: 0 (off) and 1 (on). The default is 0.
Syntax
Example
The printer does not use the on-demand sensor.
Defining the Sens orMode Tag (Optional)
The SensorMode tag specifies which sensor to use.
Valid values include: “DieCut” and “BlackMark”. The default is “DieCut”.
Syntax
Example
The printer is using the die cut sensor.