Avery Dennison Pathfinder 6057 LNT Programmer Manual using XML - Manual (Page 56)

5-2 LNT Programmer’s Manual
D e f i n i n g P ri n t e r S et u p X M L T ag s
These Printer Setup tags can be defined in the file for a single print job. Printer
settings in the file take priority over these settings defined in the LNT file.
Defining the Qua ntit y Tag (Optional)
The Quantity tag specifies the number of labels to print.
Valid values include: 1 to 999. The default is 1.
Syntax
value
Example
5
Prints 5 copies of label.
Defining the Ene rgy Tag (Optional)
The Energy tag defines the printhead energy level. The Energy tag defines the printhead
energy level. You may need to adjust this value depending on the type of supplies you are
using. For example, synthetic supplies require the High energy setting, but standard paper
does not.
Valid values include: Normal (0) and High (1). The default is Normal.
Syntax
value
Example
High
Sets the printhead energy to high for synthetic supplies.
Defining the Contrast Tag (Optional)
The Contrast tag defines the print contrast for the job. You may need to adjust this value
depending on the type of supplies you are using. For example, synthetic supplies require a
higher print contrast, but standard paper requires less contrast.
Note: Solid black print should not exceed 30% on a given square inch of the label, or the
printhead life may be decreased.
Valid values include: -100% (minimum contrast) to 100% (maximum contrast). The default is
0 (no contrast adjustment).
Syntax
value
Example
35
Sets the print contrast to 35% for this job.