Avery Dennison Pathfinder 6057 LNT Programmer Manual using XML - Manual (Page 31)

Defining Field Setup XML Tags 3-11
Defining the Origin Tag (Required)
The Origin tag defines the corner of the bar code.
It contains the following attributes: units, justification, x, and y.
Syntax
y=”value” />
units Unit of measure. Options:
Inches Inches
MM Millimeters
Pi xels Pi xels (default)
justification Justification of the bar code in respect
to the origin location. Op tions:
Left (default)
Center
Right
Note : Starting at the specified x,y coordinates, the bar co de fills in
to the right with Left justif ication.
to the left and right with Center justification.
to the left with Right justif ication.
x X-Coordinate of the corne r of the bar code. An inte ger or float (in selected
units) that is less than the width.
y Y-Coordinate of the corne r of the bar code. An inte ger or float (in selected
units) that is less than the height.
Example
Defines the left corner of the bar code starting on the x axis at 0.05 and the y axis at 0.25.
Example
y=”0.25” />
Defines the center of the bar code starting on the x axis at 0.05 and the y axis at 0.25.