Avery Dennison Pathfinder 6057 LNT Programmer Manual using XML - Manual (Page 33)

Defining Field Setup XML Tags 3-13
Defining the LineField Ta g (Required)
The LineField tag defines a line. Use lines to form borders and mark out original prices.
Note: The solid black print can not exceed 30 percent of any given square inch of the label.
It contains the following attribute: id.
Syntax
line field information
id The identifier (name) of t he line field. Any applica tions using LNT should
reference this data. Use any 32-character ma ximu m (UNICODE) string. Do
not use the same name for t wo fields or an error
occurs!
Example
line field information
Specifies a line field called “Border1” in the LNT file.
Defining the Offset1 Tag (Required)
The Offset1 tag defines the first point of a line segment.
It contains the following attributes: units, x, and y.
Syntax
units Unit of measure. Options:
Inches Inches
MM Millimeters
Pi xels Pi xels (default)
x An integer or float (in sel ected units) that is less than the <ImageW idth>.
y An integer or float (in sel ected units) that is less than the >.
Example
Sets the starting point for the line on the x axis at 0.25 and the y axis at 0.15.
Defining the Offset2 Tag (Required)
The Offset2 tag defines the ending point of a line segment.
It contains the following attributes: units, x, and y.
To create horizontal lines, keep the y values the same and only change the x values.
To create vertical lines, keep the x values the same and only change the y values.
Syntax
units Unit of measure. Options:
Inches Inches
MM Millimeters
Pi xels Pi xels (default)
x An integer or float (in sel ected units) that is less than the <ImageW idth>.
y An integer or float (in sel ected units) that is less than the >.
Example
Sets the ending point for the line on the x axis at 0.25 and the y axis at 0.75.