Avery Dennison Pathfinder 6057 LNT Programmer Manual using XML User Manual
Page 11
Introduction 1-5
These instructions are written for W indows® Mobile® Device Center:
1. Open the folder with your data files on your computer.
2. Turn on the printer and wait for the desktop to load.
3. Connect the USB cable to your computer and printer.
4. Windows® Mobile® Device Center automatically detects your printer. Click Connect
without setting up your device to continue.
5. Click File Management, then click Brow se the contents of your device.
6. Select your device.
7. Open the destination folder for the data files on the
Mobile Device (printer).
8. Drag the files from your computer to the Mobile
Device folder.
To test a LNT file with fixed data, save it to the
Mobile Device’s (printer’s)
Temp\Print folder.
To permanently save any file to the Mobile
Device (printer), save it to the
Temp\Install folder.
Make sure supplies are loaded, you have a fully charged battery, the printer is connected to a
host and ready to receive data, and you have an application in the printer. Refer to your
Operator’s Handbook for more information